This morning Devon and I met up to continue work on our project, sadly Kelly could not be here because she had a test.
I worked on our laser cut base part, which will be a circle with a once inch diameter and .6 hole in the center for the servo motor and two quarter inch holes to be used for the threading of the wires. Devon created a perfect start that will be printed for the top of our Christmas, later we are going to try and drill a hole so we can put an LED through the top and have the start light up as well, but that is on our if time permits list.
If Time Permits:
LCD screen to say Christmas sayings
Incorporate LED into the tree topper
Double joint the Christmas Tree? (somehow)
Christmas Tree having moving eyes
Twerkin Christmas Tree
Tomorrow we are all meeting up during my lab session (Section 803 with Professor Thompson at 12:30) to further work on our design and strategy for how we plan on carrying out this project. Hopefully put a bigger dent on the Arduino software code, and make plans for after break on finishing the project all together.
No comments:
Post a Comment